Removes pump howl induced by wear.

Restore and Repair Power Steering System

Improves power steering performance already after the first 30-60 miles of run. Reduces Steering Effort

Reduces noise and vibration level of the hydraulic system pump. Protects parts from wear if the oil level is low.

THE DOSAGE DEPENDS ON THE OIL SYSTEM CAPACITY - SEE DOSAGE CHART IN DESCRIPTION

The product is designed to protect against wear, restore and repair a power steering booster and other hydraulic equipment. Due to its by 20% greater* active agent’s concentration, it offers strong restoration potential to the worn out surfaces and wear protection. During treatment of the hydraulic units the product forms a protective metal-ceramic coating on the surfaces of the titling and actuating mechanisms and switchgears (valve spindles). As a result, the operation characteristics of the hydraulic equipment are restored. *Compared to XADO gel-revitalizant for Power Steering Pumps No matter how well a power steering system is maintained, high heat and friction causes metal to become worn, scratched, and deformed over time. The destruction of the surface layer occurs in high-friction areas, where entire groups of atoms – clusters - may tear off under extreme loads. Until now there was no way to reverse this inevitable metal wear. APPLICATION: Treatment of a unit with 1 -2 L hydraulic system capacity Introduce (spray) the contents of a tube (can)* in the fluid, which is warmed up to the operating temperature, in the tank of a power steering pump After the revitalizant is applied and the engine is turned on, wait 2-3 minutes and turn the steering wheel for 5 minutes Revitalization is considered complete after the mechanism has been in operation for 50 hours ( 950 miles of run) * It is recommended preliminary to dissolve the contents of the can (tube) in small amount (~ 50 ml) of used hydraulic fluid. If the fluid in the tank of a power steering pump is contaminated (opaque or has change its initial color etc.), it is recommended to change hydraulic fluid before application. DOSAGE: Oil System Capacity, L to Number of syringes (8ml), pcs needed: 1-2L = 1 Syringe 2-5L = 2 Syringes 5-8L = 3 Syringes*1GAL = 3.785L 1QT = 0.946L 1PTS = 0.47L